Micro In-Line Connector - 2 Pin Male MCIL2M

MCIL2M Micro Circular In-Line Connector — Overview

The MCIL2M is a 2-contact Micro Circular in-line subsea connector, male (pins) face, wet-mateable and rated to 10 A per contact (20 A per connector) at 7,000 m working depth. It terminates a free cable and mates mid-run, with no panel or chassis mount required.

2 Contacts 600 V AC/DC 10 A per Contact 7,000 m Depth 500+ Wet Matings IP68

Key Design Features

• Wet-mateable: mate and demate in seawater; each contact carries its own moulded O-ring seal, so a single seal failure does not flood the connector.
• SubConn Compatible: identical face geometry, contact pitch and 7/16-20 UNF-2A thread, so it retrofits existing SubConn panels and harnesses without re-machining.
• Gold-plated contacts: brass UNS-C36000 contacts hold contact resistance below 0.01 Ω across the full 500-cycle life.
• 10 A per contact: rated current with a 20 A connector limit for the 2-contact shell.
• Pressure qualified: 1,400 bar mated design depth, 800 bar open face, so the face survives handling and storage unmated.
• Moulded cable: factory-moulded strain relief, so there is no crimp joint to fail at the cable entry.

Technical Specifications

Materials

Cable & Termination

Mating & Compatibility

Typical Applications

Power drops to wet-mateable harnesses, battery and charger links, sensor spurs on an umbilical.

Notes for Selection

Pair with MCIL2F for a cable-to-cable splice, or with an MCBH2F bulkhead for a hull penetration.