LPBH2M Underwater Connector Low Profile Bulkhead Connector 2 Pin Contact Male

LPBH2M Low Profile Bulkhead Connector

The LPBH2M is a SubConn Compatible Low Profile bulkhead subsea connector, 2-contact male (pins) face, rated 600 V AC rms at 10 A per contact (max 20 A per connector). The flat low-profile body minimises hydrodynamic drag on AUV hulls, glider fairings and ROV sensor racks where a standard circular connector body would create unacceptable drag or spatial conflicts, and is rated to 700 bar / 10,000 psi (approx. 7,000 m).

2 Contacts 600 V / 10 A Max 20 A 700 bar / 7,000 m > 500 Wet Matings Low Profile Low-Drag SubConn Compatible

Key Design Features

• Low-profile, low-drag body: the flat connector profile presents minimal cross-section to water flow — significantly reduces drag on AUV hulls, glider fairings and ROV sensor racks versus standard circular connector bodies.
• High contact density in a compact body: 2 contacts in a flat rectangular footprint that fits tight instrument racks and sensor clusters.
• Wet-mateable: more than 500 wet mating cycles with wiper seals protecting the contacts.
• Gold-plated contacts: corrosion-immune, stable low-resistance paths over the full operating life.
• Flexible marine build: high-grade rubber body suited for repeated dynamic bending in instrument cables and pigtails.
• SubConn Compatible: same contact sizes as the SubConn Compatible Circular series.

Technical Specifications

Pressure & Temperature

Mechanical

Materials

Cable & Termination

Mating & Compatibility

Typical Applications

ROV systems and instrumentation bottles, oceanographic systems and instrumentation, defence systems, offshore oil and gas, renewable energy and subsea systems, underwater camera / video / lighting systems, diving systems and equipment.

Notes for Selection

Nuts and washers can be supplied in stainless steel AISI 316 or brass UNS-C36000; mounting screws in stainless steel AISI 316. Depth rating on PEEK bulkhead versions is 300 bar / 4,350 psi.